How to

How to replace a Garmin display/MFD when you CAN access the dipswitch of the original display.

Posted by Czone Online on

Buy Czone Here! 

Read more →

How to add a new Garmin display to a Czone System

Posted by Czone Online on

Attached is a step by step power point on how to add a NEW Garmin display to a Czone system . Equipment needed:  Laptop, SD card depending on the  display, and a card reader . You will also need the Czone configuration tool software.  Buy Czone Here! 

Read more →

How to replace a Garmin display on a CZone network when you CANNOT access the dipswitch settings of the original Garmin display

Posted by Czone Online on

Here is a step by step  on how to replace a Garmin display when you cannot get access to the dipswitch on the old display Equipment needed:  Laptop, SD card depending on the  display, and a card reader . You will also need the Czone configuration tool software. Buy Czone Here! 

Read more →

Activating CZone System on your Garmin display

Posted by Chris Tsang on

Click the image to enlarge image

Read more →

How do I change out a BEP Czone module

Posted by Czone Online on

To change out a BEP Czone module start by: 1. Ensure the Firmware on the replacement device matches the Device to be replaced. This link will explain how to do that: How to determine the firmware version of a Czone module. 2. Turn off power to module. 3. Disconnect all wiring connections then remove the faulty module. 5. If the module is an OI or a MOI remove the fuses from the failed module verify that the fuses are good and fit in the same locations on the new module Warning: Do not put the wrong amp fuse in the...

Read more →